Diy hook up ice maker How to Install Refrigerator Plumbing

Diy hook up ice maker

Resources 1 Ask The Builder: Continue to 4 of 7 below. Turn off the supply line.

Install It

An Adapt-a-Tee is an ideal plumbing fitting for this purpose. Avoid using the bottom of the pipe, as this may draw sediment into the ice maker.

Finally, drain the lines by opening a faucet. Wrap the female thread on the opposite end of the adapter with thread-seal tape. If you are lucky, there will be a hookup in your kitchen wall near the refrigerator. Plug in the refrigerator.

Dating culture in ireland

Adapt-a-Tees can be used in many situations where you need an extra line. You may have three water supply lines beneath the sink; two lines connect directly to the faucet while the third line connects to the dishwasher.

Tapping the Cold Water Line

Figure 6 to 8 ft. Now turn on the faucet shutoff valve under the sink and check for leaks at the Adapt-a-Tee connections. Turn the water on to flush the tube into a pail for at least 1 quart or until the water runs clear.

Sacramento local dating sites

MORE Adapt-A-Tees are easy to install, and they provide the extra line you need with the least amount of work possible. Cut a 3- to 4-in. Slide the provided water valve clamp over the fill tube, insert the water supply line and use a drill with a hex head bit to tighten everything up.

How to say hook up in french

Drain the Water Line Now that the water line has been run to the refrigerator, it's time to do what's called the "tap-in" to the cold water line underneath the sink. Attach the Adapt-a-Tee adapter to the shutoff valve, tightening by hand at first. Screw the provided screws to the mounting holes on the side of the freezer wall Image 2.

Once you're outside the last cabinet, don't attach any clamps; just run the tubing to the floor near the water hookup on the fridge. Watch for leaks at all the connections.

Free dating sites montreal

Although the braided steel is considerably more expensive, the extra strength it provides is well worth the investment. If there is no water dispenser, throw away the first full batch or two of ice to make sure it is all clean and ready to use. You hook up ice maker also need a longer flex water supply tube to run from the water pipe to the refrigerator. Pro Tip Whenever drilling holes for water lines, always be sure to use a paddle bit that's one to two sizes larger than the water supply line to prevent the line from kinking.

Required Tools for this Project

Privacy Policy Sign Up. You can buy icemaker installation kits at home centers and some hardware stores, but we don't recommend them. Connect the tubing to the valve by hook up ice maker, then turn one extra time with a wrench. Disconnect the faucet supply tube from the shutoff valve. Plug your refrigerator into the wall. Installing Automatic Ice Maker.

Add pipe compound to the threads to make it easier to tighten compression joints. Running a water line to a refrigerator to supply its ice maker and drinking water dispenser has never been easier.

Plumb the fridge

Begin installing the fill tube by placing the provided metal insert into the end of the water supply line Image 2. Pull it out a few inches Image 1.

To attach the tubing to the refrigerator, follow the owner's manual. Now that the water line has been run to the refrigerator, it's time to do what's called the "tap-in" to the cold water line underneath the sink.